Detailed Using Guidance of Glazed Tile Roll Forming Machine

In the market of roll forming machine china , there is no doubt that the glazed tile roll forming machine plays an important role in modern construction.

The following will teach you how to use the glazed tile roll forming machine in detail.

Before starting, it is necessary to check whether there is water or oil in the control cabinet. If the device is affected with damp, please do not start the device until the maintenance personnel dry the electric parts. And then check whether the power supply pressure is suitable, generally less than ±15%. And check the sc ram switch and the safety door switch front and back. And check whether the electric motor conforms to the turning direction of the oil pump. And check the smooth degree of all cooling pipes and inlet cooling water to the cooling water jacket on the end of the machine barrel and oil cooler. Inspect the oil on all moveable parts, if lack lube, supply purlin roll forming machine enough lube.  Start the electric heating and heat all ends of the machine cylinder. When the temperature of all ends meets the requirements, keep it warm for a period of time to make the temperature of the device stable. The holding time is different according to different requirements of devices as well as raw materials. And then add to enough plastic into the hopper. Some of the materials should be dry first according to different requirements of material. It is necessary to cover the heat shield on the machine barrel, which is able to save electricity energy and prolong the service time of electric heating and contactor.
　
In the middle of operation, it is forbidden to cancel the function of the safety door at will for convenience. And pay attention to observe the temperature of the pressure oil to make sure the oil temperature within the specified range. The ideal temperature of the hydraulic oil should be kept between 45 degree and 50 degree, generally 35 degrees to 60 degrees is proper. And also keep in mind to adjust all lead limit switches to avoid striking in the middle of running the metal roll forming machine.

And after working, it is possible to clear off the materials inside of the machine cylinder, preventing the left material oxygenated or resolve because of heat after a long period. And open the mould to make the toggle rod in the condition of shutting for a long period. There should be crane devices in the workshops. And be careful when install or take apart the heavy parts like mould to make sure the safety in the middle of production.   http://www.broswright.com/prolist/

Posted April 21, 2014 23:19